Touch screen is widely used in modern electronic technology production,Its excellent performance replaces the traditional glass screen,Touch screen technology is also constantly being tapped,I will explain the installation and disassembly skills of the touch screen in detail today.
Disassembly touch screen precautions
When removing the CRT,Do not grab or collide with the neck and electron gun of the CRT.Because the electron gun is a glass structure，Very easy to be broken，
Repair the touch screen front cover
After removing the CRT and the front cover of the touch screen,Try putting the touch screen into the removed touch screen front cover，Generally, some ribs are designed inside the front cover.These ribs are mainly useful when demolding during production，If it interferes with the touch screen or feels long-term use, it may damage the wires on the edge of the touch screen， It should be cut off with a diagonal pliers.
Applying a dust-proof strip to the front cover of the touch screen has two functions：1.Prevent crushing the transducer. Some touch screens such as PHILIPS front cover are not high enough，If the dust is not attached to the touch screen loaded strip will transducer is crushed, resulting in not using the touch screen。
2.Prevent outside dust from entering the touch screen stripe area，If there is too much dust on the touch screen stripe, the touch response will be slow, and the local touch will be invalid.Applying a dust-proof strip can effectively solve this problem.
Apply double-sided tape. Apply double-sided tape to the visible area of the picture tube. When the touch screen is pasted, peel off the double-sided tape.
Finishing touch screen cover. In order to observe the working state of the control box, it is recommended to install the control box on the outside of the display.But if you want to look good, you can attach the control box with double-sided adhesive tape or find a way to screw it into the inside of the display。
At the same time, use a diagonal pliers to cut a small hole in the back cover of the display that can pass through the screen or serial cable.（Note: The position of the control box and the outlet hole is not fixed, so as not to affect the internal space of the display, and does not affect the reinstallation of the display）。
Clean and paste the touch screen，Thoroughly clean both surfaces of the touch screen with a glass cleaner and suede，After cleaning, carefully center the touch screen on the screen and stick it on the screen.
Pay attention to making the reflective stripe of the touch screen outside the visible area of the picture tube while ensuring the safety of the transducer.The touch screen has three transducers with the side facing up, and immediately seals the gaps on the four sides with high temperature resistant tape to ensure that no dust enters the gap.
Reinstall the touch screen. Because the thickness of the touch screen and double-sided tape is increased between the original screen and the front cover, some rubber gaskets should be added when installing the CRT. Then put the picture tube into the front cover, connect the connection lines, lead the screen line or the serial line, and reinstall and fix the display.
Installing the touch screen precautions
If the front cover of the display is placed flat on the workbench and then the picture tube is installed in the front cover of the display, the lower part of the front cover of the display must be raised so that the touch screen does not directly touch the workbench because the surface of the touch screen is curved, otherwise it is extremely easy. Crush the touch screen during installation!
The height of the rubber gasket should be slightly higher than the total height of the touch screen and double-sided tape.
When loading the picture tube into the front cover of the monitor, pay attention to the position of the mounting hole on the positive tube and the front cover mounting hole of the touch screen. Otherwise, the touch screen image will be tilted and the installation work will be
Español
Portugues
Pусский
한국어
中文
